LED T-Molding Housing Only (0.80in, 20mm)

LED T-Molding Housing (0.80in, 20mm) is sold in feet.

This LED T-Molding Housing is a translucent t-molding with a hollow core, allowing it to be illuminated by inserting LED strips or EL (Electroluminescent) tape into it. It is priced per foot, and sells as a single piece up to 250ft long.

Please Note:
The LED strips are sold separately here:
RGB LED Strip (5050 SMD, 60/M)
LED T-Molding Accessories


* Width is 0.80" wide (20mm) +/- 0.01in (0.25mm)
* Hollow core is 0.55" wide and 0.09" high on the ends, 0.135" high in the middle.
* Fits standard non-waterproof 3/8" wide LED strips. Do *not* use waterproof strips, they are too thick to fit.
* Spine is 1/8" wide for use with a 3/32" wide slot
* Same product as Raw Thrills / Betson part #603-00718, as used on Jurassic Park and Aliens Armageddon
* LED strips sold separately

NOTE: When manufactured this molding is coiled backwards so it must be recoiled for a period of time to reverse the curve for easier installation. You may need to coil it in the other direction or lay it flat until you install it. That will help reverse the curve from manufacturing.

Product Features:
* Cool looking T-Molding when LED strip is inserted and lit
* Ideal for giving your arcade machine project the wow factor

Slot Cutter:
This T-Molding requires a 3/32" slot cutter.

How To Order:
Simply enter the number of feet you require.
For example: To order 20ft, simply enter quantity of 20.

T-Molding will always be cut and supplied in one continuous length, up to a maximum length of 250Ft (76 Metres). Any order over 250ft (76 metres) will be supplied in multiple rolls.
For example: 300ft would be supplied as 1 x 250ft roll & 1 x 50ft roll.

T-Molding Conversion:
If you usually work in metres, please enter the amount you require below to convert this into feet.
*Please note: T-Molding can NOT be ordered in fractions.
E.g. 5m = 16.404ft - This would need to be rounded up to the nearest whole number.

Metres:

Feet:

FAQ
What is T-Molding?
T-Molding is the plastic trim or edging that can be used to give a nice finish to a wide variety of products, including furniture, boats, arcade machines, slot machines, tables in VW camper vans and more. T-Molding is also commonly referred to as “plastic edging” “t trim” “plastic trim” or “t lining”

Is this T-Molding plastic and flexible?
When manufactured this molding is coiled backwards so it must be recoiled for a period of time to reverse the curve for easier installation. You may need to coil it in the other direction or lay it flat until you install it. That will help reverse the curve from manufacturing.

How do I install T-Molding?
To install T-Molding, you will need a slot cutter. Once you have cut the slot in your wood, you should be able to knock the T-Molding in with a soft faced hammer or rubber mallet. It is always advisable to practice cutting the correct slot size on an off cut of wood before you start your project to ensure a tight fit. If the slot has been cut at the correct depth, the T-Molding should be a nice tight fit, however a small bead of glue can also be used in the slot to ensure a more permanent fix.