JST-XH Female To Female Connector Cable
- Calculated at Checkout
The JST-XH female to female connector cable is approx 30cm in length and features a 5 pin female plastic header at each end. This cable can be used for connecting to various PCB projects. The JST-XH cable can be used for connecting to the TP-MA on the Sanwa JLF series of joysticks instead of using the Sanwa JLF-H 5 pin cable. The other end of the cable can then be connected to the PCB in various fight stick models.
This cable is also suitable for connecting a Sanwa JLF-TP-8YT joystick to a Venom PS4 fight stick.
* 5 pin female plastic header at each end
* Easy connection to Sanwa JLF series of joysticks
* Low cost
* 30cm length
* Plug and unplug with ease
The cable is not too long were it would be a nightmare to fit it in the case but not too short were it wouldn't reach if the case was on the larger end i.e. just right for its purpose.
The connectors are a tight fight, meaning that you had to put a tiny bit of force to get them on to their male mountings. But after it was on, it received my input from the stick with no problems. Very well done.
This cable makes it very easy to replace the stock joystick on the Venom PS4 Fightstick with a Sanwa JLF, because the necessary port is already on the PCB. It's just plug and play.
Works as expected. I havent had any issues.
more then enough length to connect both sides.
Bought these for my Venom stick and the plastic part of the plug side faces needed cutting down. This was because it was way too tight for the socket on the Venom's control board. A little trimming/sanding down, particularly on the two raised insertion arrows, fixed the problem.
Plugging it on to the Sanwa JLF was also very tight. I had to clear the plastic mould flash with a pin. Everything else I got from Arcade World has been excellent, however even though these cables do work the plugs are a bit naff. Still, no soldering and they're extremely unlikely to work lose by accident so that's good.
These cables are essential if you want to not mess about with soldering irons when customising arcade sticks like the PS4 Venom stick; as long as you make sure you fit the ribbon the right way up to the pins on the stick you can't really go wrong.
A no fuss cable for those looking for wire up a Sanwa stick without having to do any soldering. I used the one I ordered to wire said stick up to a Venom PS3/4 stick. It should be noted that the cable option I got when I checked out the stick required soldering, meaning I had to go back and buy the correct cable (the reviewed product) separately. This is really my own fault for not doing my homework but Arcade World should offer the option (and an explanation) for both types of cable for customers checking out sticks.
i, Arcade World has a cheap 48 hour delivery option, which easily bests China-based eBay/Amazon sellers that take 3-4 weeks to reach you.
ii. I ordered a full set of buttons and a stick from Arcade World which was packaged immaculately. The same amount of packing used for that shipment was used for these two puny cables I ordered. Serious overkill (seriously, an envelope will do...) but something that impressed me.
Better than soldering!