Product Description
These Ultralux LED Illuminated arcade buttons with stunning real chrome-plate look great when they are not illuminated and even better when they are! Each button is supplied with a microswitch, fixing ring and an LED with bayonet style bulb holder with 6.3mm terminals.
This button will fit a standard 28-30mm mounting hole and features a low profile surround that is only 3.8mm above the surface of the panel when mounted.
Please Note:
This button is available to order as "Button only" (No microswitch or LED included) OR "With standard microswitch & budget 12V LED included"
If you require alternative switches/LEDs, these can be ordered separately.
LED Option:
If selected, this button will be supplied with: Ultralux 5V 10mm Wedge Base LED
If not selected, alternative wedge base LEDs can be ordered separately here: LEDs & Bulbs
Microswitch Option:
If selected, this button will be supplied with: Ultralux Button Microswitch With 4.8mm Terminals
If not selected, alternative button microswitches can be ordered separately here: Microswitches
What's Included?
1 x Ultralux Chrome Plated Button
1 x Fixing Ring
1 x Bayonet Bulb Holder (6.3mm Terminals)
Lighting Your Ultralux Arcade Buttons
Full dimming control including RGB Color mixing:
See our PacLED64 LED Controller for full details
Always Lit:
If you simply want to light the buttons permanently, just connect the LEDs to a 5 volt or 12 volt power supply, e.g. from a spare molex connector on a PC power supply. Using a 6.3mm crimped Daisy Chain Harness will save a lot of time.
Simple Off/On Control:
See our Pac-Drive LED Board. This is supported by several Front End menus such as Mala, to control pre-set flash sequences and illuminate the buttons used in each game.
Please note: You can connect 12V LEDs to the PAC-Drive LED board, but these will not shine at full brightness.
Wiring Info:
This button requires 4.8mm crimped wires for connection.
1 wire for ground connection (CO) and 1 wire for signal connection (NO)
This button requires 6.3mm crimped wires/daisy chain harness to connect the terminals on the bulb holder.
Button Dimensions:
Mounting hole required: 28-30mm
Overall Diameter of button across plunger: 33mm
Maximum depth of button from top of plunger to bottom of microswitch: 66mm
Product Videos
Custom Field
Product Reviews
2 Reviews Hide Reviews Show Reviews
-
Nice quality !
Good quality leds and micro-switches !
-
Satisfied with these buttons
One must take care that the connection sizes needed are different for the bulb holders for illumination (LED) and the microswitches themselves. But it is clearly explained on the site. I just didn't read it with enough attention. The company owner Andy was very responsive, I was amazed.